![]() ![]() Racadm config -g cfgRacTuning -o cfgRacTuneRemoteRacadmEnable 0 Log/Verbose Levels Racadm config -g cfgRacTuning -o cfgRacTuneRemoteRacadmEnable 1Įnter the following command to disable remote security: Must reset the RAC controller to enable these commands.Įnter the following command to enable remote security: NOTE: It is recommended that you run these commands on your local system. Using the -r option without the previously listed options will result in a command failure. If you use the -r option, you must also use the -u and -p options to configure the RAC to accept racadm commands. Specifies the verbose level for screen output. If the -p option is used, the -i option is not allowed. Specifies the password used to authenticate the command transaction. If the -u option is used, the -p option must be used, and the -i option (interactive) is not allowed. If not specified, the default user name "racadmusr" is used. Specifies the user name that is used to authenticate the command transaction. Tells racadm to interactively query the user for the user's user name and password. Specifies the remote IP address of the controller. The base racadm command has the following options: NOTE: The racadm remote capability is supported only for the Microsoft® Windows®Ģ000, Windows Server 2003, and Red Hat Linux operating systems. You only need the IP address of the managed system. ![]() The racadm utility provides a remote capability option ( -r) that allows you to connect to the managed system and execute racadm subcommands from a remote console or management station. The racadm help displays any syntax and command-line options. Without options, racadm executes the help command, which displays a list of available tests and a one-line description of each. For example, lines that contain configuration codeįor modems, dial-in users, or demand dial-out entries are specific to DRAC III.Ĭommand-line status and configuration utility for RACs. Samples may not be applicable to your RAC. NOTICE: Commands and code samples in this section are RAC-specific. Racadm utility, you should add one- or two-second "sleep" or "delay" commands between NOTE: To limit the stress load on the managed system and the RAC when using the ![]() For more information about configuring multiple RACs, see " RAC Configuration File."įor more information about your RAC, including a list of other documents you may need, see your Dell Remote Access Controller Installation and Setup Guide. For example, when configuring in batch mode, a series of calls to the racadm utility can perform actions such as upgrading RAC firmware, setting a property to a specific value, and reading the configuration of the RAC. You can also use the racadm utility to write scripts that will automatically configure multiple RACs. When you enter racadm subcommands, the racadm utility sets or retrieves object property values in the RAC properties database. Using the racadm command, you can enter subcommands to configure RAC properties. ![]() NOTE: You can also use the Option ROM on your RAC or Dell OpenManage Server For more information about using theĭrscadm utility on PowerEdge 7150 systems, see the Remote Service Card User's However, when you use the utility on this system, the primaryĬommand is drscadm instead of racadm. NOTE: The racadm command-line utility is supported on Dell PowerEdge 7150 The racadm utility runs on the management station and the managed system and is available on the Dell OpenManage Systems Management CD (32-bit systems) and on the Dell OpenManage Server Management CD (64-bit systems). The racadm command-line utility provides a scriptable interface that allows you to locally or remotely configure your remote access controller (RAC). Using the racadm Utility to Configure the RAC ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |